INSTALLATION CHECKS:

Before beginning your installation, ensure that the wall surface must have adequate strength and construction to hang and support the weight of the mirror.

INSTALLATION PROCEDURE:

1. Measure the distance (X) between the centres of the axis of the support holes on the back of the mirror.

2. With the help of a meter and a level draw a horizontal line on the wall according to the height at which you wish to hang the mirror. Mark the position of the hole on the wall with a pencil, positions on the horizontal line using the dimension (X) taken from the previous step.

3. Using a hammer drill, drill the two holes in the marks you made in the previous step. Make sure the hole positions are horizontal.

4. Use a hammer to hammer the expansion bolt plug into the hole and hold it level with the wall.

5. Use a screwdriver to insert and tighten the screw into the expansion bolt stud.

6. Hang the mirror on the screws you have inserted, which should protrude from the wall. Make sure that the mirror is securely anchored.

7. You can then connect the mirror to the mains electricity supply.

⚠️ Remember that to remove the mirror, the mirror must first be lifted up and then detached from the wall.

SAFETY INSTRUCTIONS:

When using this mirror, basic precautions should always be followed, including the following: Read all instructions before use.

Danger. To reduce the risk of electric shock, always unplug this appliance from the electrical outlet before cleaning or servicing.

1. Disconnect power before putting on or taking off parts.

2. Close supervision is necessary when this mirror is used by or near children, infirm or handicapped persons.

3. Use this mirror only for its intended use as described in these instructions. Do not use accessories not recommended by the manufacturer.

4. Never operate this mirror if it has a damaged cord, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the mirror to a service centre for examination and repair.

5. Keep the cable away from hot surfaces.

6. Never operate the mirror with the air openings blocked. Keep air openings free of lint, hair and the like.

7. Do not use outdoors..

8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.

9. To disconnect, turn all controls to the off position and then disconnect from electrical outlet.